This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
Beamicon2 Support Forum › English language forum for Beamcion2 Basic users › Open forum
Beamicon2 (3.24) Linux does not start (Asks for parameter files...)

Linear Mode
Beamicon2 (3.24) Linux does not start (Asks for parameter files...)
Admin Offline
Administrator
*******
Posts: 178
Threads: 19
Joined: Apr 2020
#4
10-04-2025, 12:33 PM
But the Kintec-NC controller dont work with Beamicon!
You can test the Software, but to run the Controller from CNC Step you must switch to Kinetc-NC Software.
Find
Reply


Messages In This Thread
RE: Beamicon2 (3.24) Linux does not start (Asks for parameter files...) - by Admin - 10-04-2025, 12:33 PM

Forum Jump: