This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
Beamicon2 Support Forum › Deutschsprachiges Forum für die Beamicon2 › offenes Forum v
Problem mit Limit- und Referenzschaltern bei Gantry-Portal mit Slave-Achse

Linear Mode
Problem mit Limit- und Referenzschaltern bei Gantry-Portal mit Slave-Achse
Admin Offline
Administrator
*******
Posts: 166
Threads: 19
Joined: Apr 2020
#2
08-26-2025, 11:07 AM
Sind beide Referenzschalter an einem eigenen Eingang angeschlossen? Also MasterX an RefX und SlaveX and RefA zum Beispiel? Schicke einfach mal eine Supportanfrage aus dem Programm heraus, dann habe ich dei Konfigurationsdaten und kann es mir anschauen.
Find
Reply


Messages In This Thread
RE: Problem mit Referenzschaltern und Referenzfahrt - by Admin - 08-26-2025, 11:07 AM

Forum Jump: